This will put a line in each of the fields for the third QTC in the third row. For example, if QTC #3 is garbled, you click the S button next to Agn 3. When you are receiving QTCs and one of the QTCs is garbled and you don’t copy it, you can click the “S” button and it will skip that QTC so you can click on the next QTC that is good. Agn 1 asks for a repeat of QTC #1, Agn 2 asks for a repeat of QTC #2, etc. buttons are used to request a repeat of a particular QTC. The All Agn button is used to request a repeat of the entire QTC group consisting the header number and QTCs. The Hdr Agn button is used to request a repeat of the QTC Header number. The QTC header number is usually sent first, followed by the QTCs themselves. For example, a QTC header number of 3/10 means it is the third set of QTCs sent from that particular station and it consists of 10 QTCs. It represents which group and how many QTCs are in the group. A QTC Header number is actually two numbers with a slash / between them. The QTC Header field is used to populate the QTC Header number. You click on the QTC Header number and the QTCs in the Digital Interface screens as they are received to populate the fields in the Receive QTC window. In RTTY mode, once you tell the other station that you are ready, they will send the QTC Header number (also called QTC Group number) followed by the QTCs all at once. In this example, it is highlighted in green to show that is the button that should be pressed. When you are ready (QRV), press the “RX Ready” button. Typically the other station will send something like “R U QRV”. The RX Ready button is used when the other station asks you if you are ready to receive the QTCs. This is explained in more detail in the QTC Setup Button section below. The Setup button in the upper left hand corner is used to customize the messages that will be sent when you hit any of the other buttons. At the top of the window it will show “Receive QTC” and the callsign of the station you are going to receive QTCs from. The Receive QTC Window is used when you are to receive QTCs from a station outside your own continent. You MUST have a callsign of a station located in a different continent in the call field of the entry window or else you cannot open the QTC windows. When you type CTRL+Z a second time, it brings up the Transmit QTC window as shown in Fig. When you type CTRL+Z once, the Receive QTC window opens as shown in Fig. You open these windows by typing CTRL+Z (hold the CTRL key down, then press the Z key). There is one for Receive QTCs and one for Send QTCs. The definition of a QTC is shown in section 7 of the Rules.Īdditionally, the special provisions for RTTY are shown in section 12 of the Rules. In the RTTY WAEDC, stations can send and receive QTCs with any other station outside their own continent. In the CW/SSB WAE contests, stations outside Europe can only send QTCs to stations in Europe. The video is located here.Ī QTC is a copy of the data from a prior QSO in your log. This is a must-see instructional video showing how to exchange QTCs using N1MM+. There is an excellent video created by Larry, K8UT, on the N1MM website. In the RTTY portion of the WAEDC, QTC traffic can be exchanged between any two stations that are on different continents to obtain additional points. This tutorial shows how to send and receive QTCs in the Work All Europe DX Contest (WAEDC) on RTTY mode with N1MM+ Logger.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |